Radiology - Technology Information Portal
Thursday, 21 November 2024
• Welcome to Radiology-TIP.com!
     • Sign in / Create account
 
 'Range' 
SEARCH   
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 
Searchterm 'Range' found in 3 terms [
] and 39 definitions [
]
Result Pages :
Range
The range is the measurable set of numbers between the limits of the maximum and minimum values.
Bit Range
Each pixel in a digital image has a bit range, which informs the computer which color (or shade of gray) the pixel will display.
Dynamic Range
The dynamic range describes the range of x-ray intensities a detector can differentiate. A high dynamic range provides the discrimination between small differences in x-ray attenuation.
A current CT scanner has approximately a dynamic range of 1,000,000 to 1 and 1,100 views or projections a second.
Digitization
Process of conversion of continuous (analog) signals, such as the detected radiation (voltage), into numbers. This is carried out with an analog to digital converter. There are two kinds of discretization involved: the voltage is only measured (sampled) at particular discrete times and only voltages within a particular range and separated by a particular minimum amount can be distinguished. Voltages beyond this range are said to exceed the dynamic range of the digitizer.
X-Ray
X-rays are a part of the electromagnetic spectrum. X-rays and gamma rays are differentiated on the origin of the radiation, not on the wavelength, frequency, or the energy. X-rays are emitted by electrons outside the nucleus, while gamma rays are emitted by the nucleus. X-rays have wavelengths in the range of about 1 nanometer (nm) to 10 picometer (pm), frequencies in the range of 10-16 to 10-20 Hertz (Hz) and photon energies between 0.12 and 120 kilo electron Volt (keV). The energy of rays increase with decreased wavelengths. X-rays with energies between 10 keV and a few hundred keV are considered hard X-rays. The cutoff between soft or hard X-rays is around a wavelength of 100 pm.
Because of their short wavelength, X-rays interact little with matter and pass through a wide range of materials. These interactions occur as absorption or scattering;; primary are the photoelectric effect, Compton scattering and, for ultrahigh photon energies of above 1.022 mega electron Volt (MeV), pair production.
X-rays are produced when high energy electrons struck a metal target. The kinetic energy of the electrons is transformed into electromagnetic energy when the electrons are abruptly decelerated (also called bremsstrahlung radiation, or braking radiation) similar to the deceleration of the circulating electron beam in a synchrotron particle accelerator. Another type of rays is produced by the inner, more tightly bound electrons in atoms;; frequently occurring in decay of radionuclides (characteristic radiation, gamma ray, beta ray). The energy of an X-ray is equivalent to the difference in energy of the initial and final atomic state minus the binding energy of the electron.
Wilhelm Conrad Roentgen discovered this type of rays (also called Roentgen-rays) in 1895 and realized that X-rays penetrate soft tissue but are absorbed by bones, which provides the possibility to image anatomic structures; the first type of diagnostic imaging was established. Radiographic images are based on this difference in attenuation for tissue and organs of different density. Today ionizing radiation is widely used in medicine in the field of radiology.

See also Exposure Factors, X-Ray Tube, and X-Ray Spectrum.
Result Pages :
 
Share This Page
Facebook
Twitter
LinkedIn

Look
      Ups
Radiology - Technology Information Portal
Member of SoftWays' Medical Imaging Group - MR-TIP • Radiology-TIP • Medical-Ultrasound-Imaging
Copyright © 2008 - 2024 SoftWays. All rights reserved.
Terms of Use | Privacy Policy | Advertising
 [last update: 2023-11-06 02:01:00]