(T) The system international (SI) unit of magnetic flux density. Definition: 1 T is the field intensity generating 1 N (newton) of force per ampere of current per meter of conductor. The tesla unit value is defined as a field strength of 1 weber per square meter of area, where 1 weber represents 1 x 10⁸ (100 000 000) flux lines. One T is equal to 10 000 gauss, the older (CGS) unit. A field of 1 tesla is quite strong, the Earth's magnetic flux density, at its surface, is about 50 microteslas (µT).

X-rays are a part of the electromagnetic spectrum. X-rays and gamma rays are differentiated on the origin of the radiation, not on the wavelength, frequency, or the energy. X-rays are emitted by electrons outside the nucleus, while gamma rays are emitted by the nucleus. X-rays have wavelengths in the range of about 1 nanometer (nm) to 10 picometer (pm), frequencies in the range of 10^-16 to 10^-20 Hertz (Hz) and photon energies between 0.12 and 120 kilo electron Volt (keV). The energy of rays increase with decreased wavelengths. X-rays with energies between 10 keV and a few hundred keV are considered hard X-rays. The cutoff between soft or hard X-rays is around a wavelength of 100 pm.
Because of their short wavelength, X-rays interact little with matter and pass through a wide range of materials. These interactions occur as absorption or scattering;; primary are the photoelectric effect, Compton scattering and, for ultrahigh photon energies of above 1.022 mega electron Volt (MeV), pair production.
X-rays are produced when high energy electrons struck a metal target. The kinetic energy of the electrons is transformed into electromagnetic energy when the electrons are abruptly decelerated (also called bremsstrahlung radiation, or braking radiation) similar to the deceleration of the circulating electron beam in a synchrotron particle accelerator. Another type of rays is produced by the inner, more tightly bound electrons in atoms;; frequently occurring in decay of radionuclides (characteristic radiation, gamma ray, beta ray). The energy of an X-ray is equivalent to the difference in energy of the initial and final atomic state minus the binding energy of the electron.
Wilhelm Conrad Roentgen discovered this type of rays (also called Roentgen-rays) in 1895 and realized that X-rays penetrate soft tissue but are absorbed by bones, which provides the possibility to image anatomic structures; the first type of diagnostic imaging was established. Radiographic images are based on this difference in attenuation for tissue and organs of different density. Today ionizing radiation is widely used in medicine in the field of radiology.

See also Exposure Factors, X-Ray Tube, and X-Ray Spectrum.

The x-ray (or roentgen-ray) spectrum consists of electromagnetic radiation with wavelengths shorter than ultraviolet (UV) and longer than gamma rays. The usual photon energies of x-rays range from 100 electron volt (eV) to 100 keV (wavelengths of around 10 to 0.01 nanometers; or around 100 to 0.1 Angstroms); corresponding to frequencies in the range of 30 PHz to 30 EHz (see Hertz).
The energy distribution (wavelength, frequency) of x-ray photons emerges from the source, the x-ray tube. In a conventional tube, x-rays are generated in two different ways that, together, form a typical spectrum consisting of the bremsstrahlung, which is superimposed by the lines of the characteristic spectrum (in a graph, the curve is shaped like a hump topped by several spikes).

See also Angstrom, Direct Radiation, Secondary Radiation, and Radiation Meter.

The absorbed dose is the average energy absorbed per unit mass.

The tissue absorbed energy in a small mass volume:
D = (dW/dm) [ Gy ]
D = absorbed dose in Gray (Gy); dW = in the tissue energy absorbed; DM = small volume of the mass.

The SI unit of absorbed dose is the joule per kilogram and its special name is the gray (Gy). In units often used by federal and state agencies, absorbed dose is given in rad; 1 rad = 0.01 Gy.

Absorbed dose is a feature that should increase dose awareness and help users in dose optimization. Absorbed dose in CT is quoted using the CTDI (computed tomography dose index)

CTDIvol (volume-averaged CT dose index) and the dose-length product (DLP) give an indication of the average absorbed dose and relative radiation risk to a standard patient. The user is being warned to scan parameter settings that may lead to high doses, and can adjust the protocol if appropriate. It should be noted that CTDIvol and DLP do not take patient size into account, and will give overestimates and underestimates for large and small patients, respectively.

An assay is an analytic test to detect the presence, measure the concentration, and determine the biological activity of molecule, ions, or cells. Assays are based on measurable parameters that enable the evaluation of differences between samples and controls. Sensitivity, the ability to detect small amounts of a substance, and specificity, the ability to detect only the analyte, are essential features of an assay.

See also Bioassay, Biochemical, Biohazards, Biokinetic Model and Bioaccumulation Factor.