A cassette is a thin, low x-ray absorption plastic case, for holding the x-ray film. Inside the cassette are intensifying screens for the conversion of x-rays to visible light photons. The intensifying screens are mounted in close contact with the film. Mammography cassettes are equipped with single screens.

An intensifying screen is used to intensify the x-ray effect during radiation exposure of the x-ray film. Approximately 5% of the x-ray photons will be absorbed by the film only. Intensifying screens consist of a sheet of inorganic salts that emits fluorescent light when stroked by x-rays. The fluorescent input and output screens of the image intensifier are very similar to intensifying screens.
Calcium tungstate and rare earths are two common salts (also called phosphors) used for intensifying screens. For example, a calcium tungstate (CaWo4) screen can absorb around 40% of the x-ray photons and convert the radiation into light photons. A basic feature of this screen types is related to the position of the k-edge on the energy axis. Tungsten (W) is a heavy element has a k-edge at 69.5 keV, while that for rare earth elements is in around 50 keV.
The fraction of x-rays absorbed by a screen is depending on the speed. Factors affecting the speed of a screen: Mammography cassettes contain usually one intensifying screen, but most others use two screens per film cassette. The intensifying screen as part of a film screen system has been an important component in radiology to reduce the radiation dose of the patient. Today, the conventional film cassette is being replaced by an imaging plate used in digital systems.

See also Actinides, Cinefluorography and Added Filtration.

An imaging plate is used in computed radiography (CR) instead of a conventional film cassette.
The imaging plate is coated with photostimulable phosphors. The phosphor layer is doped with special substances to alter the crystalline structure and physical properties. After radiation, the enhanced phosphor material absorbs and stores x-ray energy in gaps of the crystal structure, building a latent image.
Usually, the storage phosphors are stimulated with a low-energy laser to release visible light at each point of x-ray absorption. To read-out the image, the plate is inserted into a computed radiography scanner. The scanning laser beam causes the electrons to relax to lower energy levels, emitting light that is captured by a photo-multiplier tube and converted into an electrical signal. The electronic signal is then converted to digital data and can be displayed on laser-printed films, workstations, transmitted to remote systems, and stored digitally.
The CR units automatically erase the image plate after the complete scan. Phosphor imaging plates, like film, are stored in cassette format and can be re-used very often if they are handled carefully. Existing conventional x-ray equipment, from generators to x-ray tubes and examination systems, can be used with imaging plates.

(MLO) The mediolateral-oblique view is one of the standard two views of the breast. The image receptor of the mammography system is horizontally angled 30 to 60 degrees. The cassette assembly is parallel aligned to the pectoral muscle and the corner of the cassette holder fits comfortably into the axilla. The x-ray beam is directed from the superomedial to the inferolateral part of the breast.

A Bucky is a component of x-ray units that holds the x-ray film cassette and moves the grid during x-ray exposure. The motion keeps the lead strips from being seen on the x-ray picture.
The name refers to Dr. Gustave Bucky who invented the use of filter grids in 1913.